Liquid detector IP65 Brahms RLI02

VAT-inclusive price

1200 Raccolta Punti

Liquid detector IP65 Brahms RLI02 Cod. 64400010
The detector of liquids RLI02 and 'was designed to detect the presence of water or other conductive liquid. It is thus allowed to control environments or where a particular local allgamento could cause severe damage to the equipment installed.
The sensitivity of the detector is ≤100KΩ, the presence of a resistance in this range of values causes the excitation of a relay that can be used to drive loads up to 1A 30Vdc or 110Vdc or 0.3A 0.5A 125Vac.
The unit can be positioned at will by simply resting on the floor or fixed to a vertical wall at the desired height. When a film of water of even only a mm is in contact with the terminals the unit goes into alarm.
Power is normally 13.8Vcc is accepted but also supply max 27.6Vcc, so you can use the unit with 24VDC powered systems.

  • Dimensions (cable and contacts excluded): 120 x 37 x 27 mm
  • Cable length: 2 m
  • Weight: 260 gr
  • Degree of protection: IP65
  • Operating Temperature: -5 ° C to + 50 ° C
  • Power supply: from + to + 10.5Vcc 27.6Vcc
  • Absorption: 9.5 mA +/- 10%
  • Alarm absorption: 40 mA +/- 10%
  • Sensitivity: ≤100KΩ
  • Max voltage applicable to TEST: 27.60 + 0,5Vcc
  • Min voltage applied to TEST: 5.00 - 0,5Vcc
  • Contacts: at a.c. to eliminate the electrolysis 1.5KHz +/- 10%
Note: Do not use with flammable liquids.