Outdoor siren HPA703XP Elkron high power flash

VAT-inclusive price
202.86EUR

1663 Raccolta Punti

Outdoor siren cast aluminum. Flash signaling with LED technology.

 

HPA703XP COD. 80HP8700211

  • Sirena cast aluminum metallic silver painted
  • Flash signaling technology in high-power LEDs
  • Control by microprocessor
  • Sound pressure level: 103 dB (A) @ 3 m
  • Internal cage protection shatterproof galvanized
  • System opening and removal
  • Electronic protection anti-drilling series
  • Electronic protection, anti-foam series
  • Overtemperature (torch, thermal lance)
  • Striking Steel: Optional
  • Start block function
  • Alarm log (by blinking the flash)
  • Programmable mode played on 16 different modulations with 2 modes played
  • comply with IMQ. DEMO function for listening to different modulation played
  • (With reduced loudness).
  • Self-diagnosis fault drums and trumpet
  • Preparing mini spirit level
  • Ability to program the inputs of the block (BL) and TC as balanced or normally closed, referred to positive or negative.
  • Time-out played in case of permanent lack of block (4 different programmable timings).
  • Count cycle play (can be disabled)
  • Battery test (under load), flashlight integrity and horn
  • Fault output for low battery, interruption or short-circuit the module flash, breaks or shorts trumpet, malfunction protection module (if present).
  • Alarm log (by blinking the flash)
  • Protection against reverse polarity and battery power from the control panel
  • Protection against opening and removal
  • System status function for "scaffolding"
  • Signalling of "state failure" and "System Status"
  • Rated supply voltage: 13.8 Vdc, 14.4 Vdc
  • Operating voltage (min - max): 9 - 15 VDC
  • Stand-by consumption: 8 mA
  • Maximum absorption in alarm: 1550 mA
  • Absorption maximum from control 150 mA
  • Flash absorption: 900 mA peak, 65 mA average
  • Operating frequency: 1400 to 1600 Hz
  • Blocking voltage inputs (NC to positive: 4.3 Vdc min. ÷ Vdc max)
  • Blocking voltage inputs (balanced to positive): 3.5 min ÷ 7.5 Vdc max
  • Low battery threshold: 11.2 Vdc 11.4 Vdc ÷
  • Micro-switch opening / removal: 1 A @ 24 Vdc
  • Contact tamper protection module (solid state relay): 50 mA @ 50 Vdc, R = 20 ohm type.
  • Operating temperature stated by the manufacturer: -25 ° C to +70 ° C
  • Certified working temperature (CEI): -25 ° C to +55 ° C
  • Degree of Protection by the manufacturer: IP43 / IK06
  • Case protection certificate (CEI): IP34
  • Battery compartment: 12 V / 2.2 Ah
  • Dimensions (WxHxD): 237 x 287 x 90 mm

Categories

Manufacturers