The duplication procedure must be carried out near the receiver.

1. Press buttons 1 and 2 of the source remote control simultaneously for a few seconds (until the LED lights up)

2. Press the source remote control key

3. Within 10 seconds, press buttons 1 and 2 of the new remote control (to be programmed) simultaneously for a few seconds (until the LED lights up)

4. Press the key of the new remote control (to be programmed) to complete the learning.

Wait at least 10 seconds and try to open the gate with the newly programmed remote control. To duplicate other remote controls, repeat the operation starting from point 1.

If the procedure is not successful or if errors are made during programming, wait 20 seconds and start the programming operation again from point 1.

NOTE:

In the old versions of Mitto 2 and Mitto 4 there is a hidden key. In this case, pressing the first two keys is replaced by pressing the hidden key.