BFT Mitto BRCB 02 R1 remote control, two-button version, frequency 433.92 MHz, replacement model for all previous Mitto models.
The coding of this model is HCS rolling code safety, for programming the BFT B rCB02-R1 remote control there are two ways: directly on the radio board or remotely using as master, a remote control already coded and functioning on the system.
The 12 volt 23A cylindrical alkaline battery is supplied with the remote control. Manufacturer code: D111904 - Other code written on the back of the remote control BFT B RCB02 36015
The duplication procedure must be carried out near the receiver.
1. Press buttons 1 and 2 on the source remote control simultaneously for a few seconds (until the LED lights up)
2. Press the source remote control button
3. Within 10 seconds, press buttons 1 and 2 of the new remote control (to be programmed) simultaneously for a few seconds (until the LED lights up)
4. Press the button on the new remote control (to be programmed) to complete the learning.
Wait at least 10 seconds and try to open the gate with the newly programmed remote control. To duplicate other remote controls, repeat the operation starting from point 1.
If the procedure is not successful or if you make mistakes during programming, wait 20 seconds and restart the programming operation from point 1.
NOTE:
In the older versions of Mitto 2 and Mitto 4 there is a hidden button. In this case, pressing the first two buttons is replaced by pressing the hidden button.
Buy everything you want, in 3 interest-free installments with Afterpay
Become an official reseller, exclusive advantages for you
Official V-TAC Italia distributor, buy wholesale as a reseller
Buy by phone, also an opportunity to get to know each other